Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
    3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a design of the car with 1988 to 1993
         3.2.1.1. The engine 2,3 дм3
          3.2.1.2. The engine 1,8 дм3
          3.2.1.3. Fuel system
          3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and engine installation
         3.2.1.6. Engine dismantling
         3.2.1.7. Check of details
         3.2.1.8. Check of backlashes of a cranked shaft and rods
         3.2.1.9. Engine assemblage
         3.2.1.10. Greasing system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. A mechanical five-speed transmission of type МТ 75
         3.2.1.14. A power shaft and the back bridge
         3.2.1.15. Steering system
         3.2.1.16. A forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. The electric equipment
         3.2.1.19. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment


3.2.1.16. A forward suspension bracket
THE GENERAL DATA

THE STABILIZER

Since March, 1989 (a code of date of manufacturing "KM") the plug of the lever of the stabilizer and suspension bracket levers are established new type.

Check and adjustment of a convergence of wheels


The prevention

During adjustment of a convergence of wheels steering draughts on both parties should be turned on the same corner.


PERFORMANCE ORDER
1. To weaken counternuts of steering draughts.
2. To remove collars of fastening of protective casings from the case of steering transfer.
3. To turn steering draughts:
      – For convergence increase – on the left side clockwise, on the right side counter-clockwise;
      – For convergence reduction – on the left side counter-clockwise, on the right side clockwise.
4. To tighten counternuts of steering draughts.
5. To establish collars of fastening of protective casings.

Other information, concerning a technical characteristics, adjustment and repair of a forward suspension bracket, is resulted in subsection 9.1.