Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
    3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a design of the car with 1988 to 1993
         3.2.1.1. The engine 2,3 дм3
          3.2.1.2. The engine 1,8 дм3
         - 3.2.1.3. Fuel system
            3.2.1.3.1. The fuel filter
            3.2.1.3.2. Removal and installation of atomizers
            3.2.1.3.3. The fuel pump
          3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and engine installation
         3.2.1.6. Engine dismantling
         3.2.1.7. Check of details
         3.2.1.8. Check of backlashes of a cranked shaft and rods
         3.2.1.9. Engine assemblage
         3.2.1.10. Greasing system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. A mechanical five-speed transmission of type МТ 75
         3.2.1.14. A power shaft and the back bridge
         3.2.1.15. Steering system
         3.2.1.16. A forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. The electric equipment
         3.2.1.19. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment





3.2.1.3. Fuel system

3.2.1.3.1. The fuel filter
THE GENERAL DATA

System of injection of fuel

1 – the fuel pump,
2 – the proof-reader of an advancing of injection of the cold engine,
3 – a regulator of a dose of fuel,
4 – the electromagnetic valve of deenergizing
The engine (valve STOP),
5 – pipelines of injection,
6 – an atomizer,
7 – the pipeline of return of fuel,
8 – a washer of thermal isolation,
9 – a candle накаливания

Knot of the fuel filter


1 – a replaced element of the filter,
2 – an arm of the filter,
3 – a drain bolt,
4 – the pipeline connecting the filter with the fuel pump

Knot of the air filter

 
1 – the case of the filter,
2 – a replaced element of the filter,
3 – a cover of the filter,
4 – a branch pipe of giving of air to the filter,
5 – a branch pipe of giving of air to турбокомпрессору

Removal

PERFORMANCE ORDER
1. To disconnect from the accumulator a weight wire.
2. Under the fuel filter to establish capacity for following fuel.
3. To unscrew an average bolt of fastening of the fuel filter, holding the filter and a glass sediment bowl.
4. To take a replaced element of the fuel filter.
5. To take a lining of round section and a lining of the top and bottom part of the case of the filter.

Installation

PERFORMANCE ORDER
1. To establish a new lining of round section of a replaced element of the fuel filter and new linings of both parts of the case of the filter.
2. To insert a replaced element of the filter and a sediment bowl, slightly to screw in an average bolt and, having convinced by that all elements are on the places, to tighten an average bolt.
3. To unscrew a bolt of removal of air from the filter and to pump up the manual pump while following fuel will not contain air vials.
4. To tighten a bolt of removal of air from the filter.
5. To connect to the accumulator a weight wire.
6. To start the engine and to check up tightness of connections.
7. To clean capacity with the flowed out fuel.