Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
   - 3.1. Cars with petrol engines
      3.1.1. Weights and transfer numbers
      3.1.2. Operational liquids
      - 3.1.3. Changes in a design of the car with 1984 to 1986
         3.1.3.1. The engine
         3.1.3.2. A head of the block of cylinders
         3.1.3.3. The block of cylinders of the engine
         3.1.3.4. The Krivoshipno-shatunnyj mechanism
         3.1.3.5. A cranked shaft
         3.1.3.6. System timing
         3.1.3.7. An engine mount
         3.1.3.8. Cooling system
          3.1.3.9. The carburettor
         3.1.3.10. System of injection of fuel
         3.1.3.11. Ignition system
         3.1.3.12. Coupling
         3.1.3.13. A mechanical four-speed transmission
         3.1.3.14. A mechanical five-speed transmission
          3.1.3.15. Automatic transmission Ford A 4 LD
         3.1.3.16. A power shaft and the back bridge
         3.1.3.17. System of a steering with the hydraulic booster
         3.1.3.18. A forward suspension bracket
         3.1.3.19. A back suspension bracket
         3.1.3.20. Brake system
          3.1.3.21. The electric equipment
         3.1.3.22. The general data
       3.1.4. Changes in a design of the car with 1987 to 1989
       3.1.5. Changes in a design of the car with 1990 till February, 1993
    3.2. Cars with diesel engines
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

3.1.3.20. Brake system

THE GENERAL DATA

Identification of an arm of a support of a disk brake

And – the holder of old type,

In – the holder of new type

FORWARD BRAKES

Fastening of a brake disk

Since August, 1983 (the code of date of manufacturing "DТ") is cleaned the screw of fastening of a brake disk to a wheel nave.

The brake disk is connected to a nave of a wheel by means of a spring clip on a bolt of the wheel, identical used on drums of back brakes.
The prevention
In this connection change in the cars made since August, 1983, in the course of removal of a brake disk it is necessary to mark чертилкой a relative positioning of a brake disk and a wheel nave that at installation it was possible to keep an initial arrangement of a brake disk concerning a nave. Otherwise the brake disk can have excessive palpation.

Brake support

Since May, 1983 (a code of date of manufacturing "DL") the cars made in Genk, and since June, 1983 (a code of date of manufacturing "DY") also the cars made in Dagen-ham and Cork, are equipped with arms of supports (fig. Identification of an arm of a support of a disk brake see) and supports of new type, and also brake колодками with the linings excluding fluctuations. The entered changes do not change an order of dismantling and assemblage of brakes and a method of replacement brake колодок, described in subsection 10.2.

Brake liquid

New brake liquid Ford SAM 6 C 9103 A was regularly entered. The new brake liquid can be applied to completion of quantity before a used liquid. In the course of replacement it is necessary to use a new brake liquid.

Other information, concerning a technical characteristics, adjustment and repair of brake system, is resulted in section 10.