Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
   - 3.1. Cars with petrol engines
      3.1.1. Weights and transfer numbers
      3.1.2. Operational liquids
      - 3.1.3. Changes in a design of the car with 1984 to 1986
         3.1.3.1. The engine
         3.1.3.2. A head of the block of cylinders
         3.1.3.3. The block of cylinders of the engine
         3.1.3.4. The Krivoshipno-shatunnyj mechanism
         3.1.3.5. A cranked shaft
         3.1.3.6. System timing
         3.1.3.7. An engine mount
         3.1.3.8. Cooling system
          3.1.3.9. The carburettor
         3.1.3.10. System of injection of fuel
         3.1.3.11. Ignition system
         3.1.3.12. Coupling
         3.1.3.13. A mechanical four-speed transmission
         3.1.3.14. A mechanical five-speed transmission
          3.1.3.15. Automatic transmission Ford A 4 LD
         3.1.3.16. A power shaft and the back bridge
         3.1.3.17. System of a steering with the hydraulic booster
         3.1.3.18. A forward suspension bracket
         3.1.3.19. A back suspension bracket
         3.1.3.20. Brake system
          3.1.3.21. The electric equipment
         3.1.3.22. The general data
       3.1.4. Changes in a design of the car with 1987 to 1989
       3.1.5. Changes in a design of the car with 1990 till February, 1993
    3.2. Cars with diesel engines
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

3.1.3.14. A mechanical five-speed transmission

THE GENERAL DATA

Installation of the new needle bearing of an intermediate shaft of a mechanical 5-step transmission

And – remote rings,

In – bearing needles

Bearings of an intermediate shaft

Since May, 1983 (a code of date of manufacturing "DL") the new decision of placing of an intermediate shaft in bearings in all five-speed transmissions is entered. The length of needles of bearings is changed to 25,75 mm (before 33 mm).

At replacement of needle bearings in transmissions of earlier date of manufacturing it is possible to use new bearings, thus it is necessary to establish necessarily two additional (not applied in the new decision) remote rings with a factory designation 839 Е-7125-АА-6094966.
The prevention
Two additional rings it is necessary to have the bearing.

Other information, concerning a technical characteristics, adjustment and repair of a mechanical five-speed transmission, is resulted in subsection 6.2.