Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
   - 3.1. Cars with petrol engines
      3.1.1. Weights and transfer numbers
      3.1.2. Operational liquids
       3.1.3. Changes in a design of the car with 1984 to 1986
      - 3.1.4. Changes in a design of the car with 1987 to 1989
         3.1.4.1. Engine OHC
          3.1.4.2. Engine CVH 1,8 дм3
          3.1.4.3. Engine DOHC
          3.1.4.4. Service and repair
          3.1.4.5. Coupling
         3.1.4.6. A mechanical five-speed transmission of type
          3.1.4.7. A mechanical five-speed transmission of type МТ 75
         3.1.4.8. An automatic transmission
         3.1.4.9. A forward suspension bracket
         - 3.1.4.10. Brake system
            3.1.4.10.1. Technical characteristics
            3.1.4.10.2. Service and repair
            3.1.4.10.3. Adjustment of a manual brake
            3.1.4.10.4. Removal of air from brake system
            3.1.4.10.5. Antiblocking system
            3.1.4.10.6. Check of functioning ABS
            3.1.4.10.7. Hydraulic knot of management
            3.1.4.10.8. The gauge of speed of rotation of wheels
          3.1.4.11. The electric equipment
         3.1.4.12. The general data
       3.1.5. Changes in a design of the car with 1990 till February, 1993
    3.2. Cars with diesel engines
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

3.1.4.10.7. Hydraulic knot of management

THE GENERAL DATA

Sockets of electric wires of hydraulic knot of management

1 – a socket of knot of electromagnetic valves,

2 – a socket of the main electromagnetic valve,

3 – a socket of the gauge of fires of braking,

4 – a socket of the hydraulic pump

Removal

PERFORMANCE ORDER

1. To switch off ignition.

2. To lower pressure in hydraulic system.

3. To remove a sheet casing of hydraulic knot of management.

4. To disconnect sockets of electric wires from hydraulic knot of management.

5. To clean by means of a syringe a brake liquid from a tank.

6. To disconnect hydraulic pipelines from management knot.

7. To close corresponding заглушками apertures in pipelines and картере hydraulic knot of management.

8. To remove a floor covering under a brake pedal.

9. To unscrew bolts of fastening of hydraulic knot of management.

10. To remove hydraulic knot.

The prevention
After removal of hydraulic knot of management not to touch a pusher core.

Installation

PERFORMANCE ORDER

For installation of hydraulic knot of management it is necessary to execute actions in return sequence in relation to process of its removal. After installation of hydraulic knot of management it is necessary to remove air from brake system (subsection 3.1.4.10.4 see).