Ford Sierra


Ford Sierra
1.2. Car identification
2. Maintenance service
- 3. The general data
   - 3.1. Cars with petrol engines
      3.1.1. Weights and transfer numbers
      3.1.2. Operational liquids
       3.1.3. Changes in a design of the car with 1984 to 1986
      - 3.1.4. Changes in a design of the car with 1987 to 1989
         3.1.4.1. Engine OHC
          3.1.4.2. Engine CVH 1,8 дм3
          3.1.4.3. Engine DOHC
          3.1.4.4. Service and repair
          3.1.4.5. Coupling
         3.1.4.6. A mechanical five-speed transmission of type
          3.1.4.7. A mechanical five-speed transmission of type МТ 75
         3.1.4.8. An automatic transmission
         3.1.4.9. A forward suspension bracket
         - 3.1.4.10. Brake system
            3.1.4.10.1. Technical characteristics
            3.1.4.10.2. Service and repair
            3.1.4.10.3. Adjustment of a manual brake
            3.1.4.10.4. Removal of air from brake system
            3.1.4.10.5. Antiblocking system
            3.1.4.10.6. Check of functioning ABS
            3.1.4.10.7. Hydraulic knot of management
            3.1.4.10.8. The gauge of speed of rotation of wheels
          3.1.4.11. The electric equipment
         3.1.4.12. The general data
       3.1.5. Changes in a design of the car with 1990 till February, 1993
    3.2. Cars with diesel engines
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



3.1.4.10.3. Adjustment of a manual brake
THE GENERAL DATA
The prevention

Adjustment of a manual brake is carried out after replacement brake колодок back brakes, cables of a manual brake or the lever of a manual brake in a body. In other cases performance of all actions on adjustment is forbidden.

PERFORMANCE ORDER
1. To check up, whether the lever of a manual brake is released.
2. To establish the car on the lift so that back wheels hanged down freely.
3. To unblock a counternut of adjustment of a cable of a manual brake.
4. Completely to unscrew an adjusting nut and as much as possible to weaken a cable of a manual brake.
5. To check up, whether move a cable and levers at supports without excessive resistance.
6. Gradually to pull a cable, tightening an adjusting nut before achievement of contact of tips of cables with levers of a manual brake on back supports. Levers should not move.
7. To check up, whether levers on supports move at switching of the lever of a manual brake from the first on the second tooth of a latch and to block a counternut an adjusting nut.
8. To lower the car.