Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
    4.1. Petrol engines
   - 4.2. The diesel engine
       4.2.1. Technical characteristics
      4.2.2. Check and adjustment of backlashes of valves
       4.2.3. Fuel system
       4.2.4. Atomizers
      4.2.5. Candles накаливания
      4.2.6. Compression check
      4.2.7. Removal of air from fuel system
      4.2.8. The fuel filter
      4.2.9. The fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      - 4.2.11. The repair which is not demanding removal of the engine
          4.2.11.1. A head of the block of cylinders
         4.2.11.2. Removal and engine installation
         - 4.2.11.3. Dismantling, repair and engine assemblage
            4.2.11.3.1. Installation of the back radical bearing
            4.2.11.3.2. Assemblage of knot the piston-rod
            4.2.11.3.3. Assemblage of a drive of system timing
            4.2.11.3.4. The further assemblage of the engine
          4.2.11.4. Greasing system
          4.2.11.5. Cooling system
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment


4.2.11.3.4. The further assemblage of the engine
PERFORMANCE ORDER
1. To establish a pulley of a cranked shaft.
2. To eliminate traces of oil or greasing on a bolt of fastening of a pulley of a cranked shaft, a washer and from a surface of connection of a pulley and a washer.
3. To put 3 drops of glue Frenetanch on a carving in an aperture of a cranked shaft.
4. To tighten a bolt of fastening of a pulley of a cranked shaft the corresponding moment.
5. To establish a head of the block of cylinders of the engine (subsection 4.2.11.1.1 see).
6. To establish coupling (subsection 5.2 see).
7. To establish the fuel pump and to adjust the injection moment (subsection 4.2.9 see).
8. To establish:
  – A cover of a head of the block of cylinders together with a new lining (a lining to paste to a cover to tighten nuts the moment of 3 Nanometers);
  – The thermostat of a regulator of the raised number of turns of the cold engine together with a new copper lining and to tighten its moment of 22,5 Nanometers;
  – Candles накаливания, their electric wire and токовую the tyre; candles to tighten the moment of 50 Nanometers;
  – Pipelines of giving of fuel;
  – The generator together with the holder of the tension device;
  – The holder of the oil filter together with a new lining;
  – The pipeline of giving of oil to an axis of levers of valves.
9. To attach a forward exhaust pipe to a final collector
10. To establish tension devices клиновых belts, the auxiliary pump of system of a steering, the vacuum pump and the radiator fan.
11. To put on and pull клиновые belts.
12. To measure a backlash of a drive of the oil pump.