Ford Sierra


Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
    4.1. Petrol engines
   - 4.2. The diesel engine
       4.2.1. Technical characteristics
      4.2.2. Check and adjustment of backlashes of valves
       4.2.3. Fuel system
       4.2.4. Atomizers
      4.2.5. Candles накаливания
      4.2.6. Compression check
      4.2.7. Removal of air from fuel system
      4.2.8. The fuel filter
      4.2.9. The fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      - 4.2.11. The repair which is not demanding removal of the engine
          4.2.11.1. A head of the block of cylinders
         4.2.11.2. Removal and engine installation
          4.2.11.3. Dismantling, repair and engine assemblage
         - 4.2.11.4. Greasing system
            4.2.11.4.1. The oil pump
            4.2.11.4.2. Check of pressure of oil
          4.2.11.5. Cooling system
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.2.11.4. Greasing system

4.2.11.4.1. The oil pump
THE GENERAL DATA

Greasing system
1 – the oil pump,
2 – маслоприемник the pump,
3 – the oil pallet,
4 – a drain stopper,
5 – a lining of the oil pallet,
6 – the holder of the oil filter,
7 – the gauge of pressure of oil, 		8 – an oil radiator,
9 – the oil filter,
10 – directing the index of level of oil,
11 – the index of level of oil,
12 – a gear wheel of a drive of the oil pump,
13 – a bolt of fastening of the oil pump

The oil pump

 1 – a cover,

2 – маслоприемник,

3 – a shaft with a gear wheel,

4 – the case,

5 – the valve,

6 – a gear wheel

Removal

PERFORMANCE ORDER
1. To merge oil from the engine.
2. To disconnect from the accumulator a wire of weight and to remove the air filter.
3. To take the top sheet casing of a radiator and to disconnect two holders of an engine mount.
4. To adhere the engine by means of the lift (the adaptation 21.060).
5. To unscrew bolts and to remove the oil pallet.
6. To unscrew a stopper on the case of the oil pump.
7. To unscrew a nut with the muffled aperture, to take a washer; to unscrew a bolt of fastening of the oil pump and to take it together with a washer.
8. To take from within the block of cylinders the oil pump 1 (2 – a pump power shaft).

Installation

PERFORMANCE ORDER
1. To establish the oil pump in the block of cylinders of the engine so that конусное an aperture in its case was opposite to an aperture with a carving for a fastening bolt.
2. To establish a copper washer, to tighten a bolt of fastening of the oil pump and a nut with the muffled aperture together with a washer.
3. To measure width of a backlash between surfaces of a stopper with a carving and the block of cylinders of the engine.
4. To establish a washer in the thickness of 0,05-0,10 mm for maintenance of a corresponding working backlash.
5. Other actions to execute in return sequence in relation to process of removal of the oil pump.