Ford Sierra


Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
    4.1. Petrol engines
   - 4.2. The diesel engine
       4.2.1. Technical characteristics
      4.2.2. Check and adjustment of backlashes of valves
       4.2.3. Fuel system
       4.2.4. Atomizers
      4.2.5. Candles накаливания
      4.2.6. Compression check
      4.2.7. Removal of air from fuel system
      4.2.8. The fuel filter
      4.2.9. The fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      - 4.2.11. The repair which is not demanding removal of the engine
          4.2.11.1. A head of the block of cylinders
         4.2.11.2. Removal and engine installation
          4.2.11.3. Dismantling, repair and engine assemblage
          4.2.11.4. Greasing system
          4.2.11.5. Cooling system
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.2.11.2. Removal and engine installation
THE GENERAL DATA

Holders of an engine mount

 1 – the right holder,

2 – the left holder,

3 – a right metallo-rubber connector,

4 – a left metallo-rubber connector,

5 – an engine mount cross-beam

Removal

PERFORMANCE ORDER
1. To disconnect and remove the accumulator. To remove a cowl.
2. To remove the air filter and to muffle an entrance air aperture of an inlet collector.
3. To merge cooling liquid from cooling system (subsection 4.2.11.5.1 see) and to remove a radiator together with the holder.
4. To disconnect pipelines of a heater of salon of the car.
5. To disconnect fuel hoses.
6. To disconnect electric wires from the engine.
7. To disconnect a forward exhaust pipe from a final collector.
8. To remove the auxiliary pump of system of a steering, without disconnecting from it pipelines, and to suspend it to a wing.
9. To disconnect a cable of a pedal of an accelerator from the fuel pump.
10. To remove a starter.
11. To unscrew bolts of fastening of holders of a suspension bracket from the engine and to prop up system timing under картером couplings.
12. To unscrew the bolts connecting the engine with a transmission.
13. To hook on a cable for скобы for lifting in front and behind a head of the block of cylinders.
14. By means of the lift to move the engine forward and to disconnect it from a transmission, and then to lift the engine upwards and to take it from a motor compartment of the car.

Installation

PERFORMANCE ORDER
1. To establish the engine in a motor compartment and to check up, whether it is correct it it is established concerning a transmission.
2. To tighten the bolts connecting the engine with a transmission, and then bolts of holders of an engine mount.
3. To connect hoses of system of cooling and to fill with its corresponding liquid.
4. To connect a cable of a pedal of an accelerator to the fuel pump and to adjust its tension.
5. To connect fuel hoses and to remove air from fuel system.
6. To establish and connect the accumulator; to establish the air filter and a cowl.
7. To start the engine and to check up its work.