Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
         - 4.1.4.1. Carburettor Ford with changeable section диффузора
            4.1.4.1.1. Removal and carburettor installation
            4.1.4.1.2. Dismantling, check and carburettor assemblage
            4.1.4.1.3. Adjustment of number of turns of idling of the engine and the maintenance WITH
            4.1.4.1.4. Starting arrangement adjustment
            4.1.4.1.5. Adjustment of a cable throttle заслонки
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. A diaphragm of a vacuum regulator
          4.1.4.2. Carburettor Weber 32/36 DGAV
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.1.4.1.7. A diaphragm of a vacuum regulator

THE GENERAL DATA

Vacuum regulator of the carburettor

At diaphragm damage there is no management air заслонкой.

Work выполнчется on the carburettor removed from the engine.

Removal

PERFORMANCE ORDER

1. To unscrew 4 screws and to remove the case of a vacuum regulator and a spring.

2. To disconnect from a pusher a diaphragm and to get it.

Installation

PERFORMANCE ORDER

1. To fix a diaphragm on a pusher thus having combined a vacuum aperture of a diaphragm with the channel in the carburettor.

2. To establish the case of a vacuum regulator with a spring and to screw screws, without tightening them.

3. To open air заслонку and definitively to tighten screws.

4. After carburettor installation on the engine to adjust turns of idling and the maintenance окиси carbon (WITH).