Ford Sierra


Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
       4.1.4. Fuel system
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.12. System timing

SEALING RING OF THE CAM-SHAFT

Replacement

PERFORMANCE ORDER
1. To disconnect from the accumulator a wire of weight and to merge a liquid from cooling system (subsection 4.1.14.1 see).
2. To disconnect from a radiator the top and bottom elastic pipeline.
3. To remove a casing of a gear belt. To weaken bolts of fastening of the tension device, to move its roller, overcoming resistance of a spring, and to tighten bolts of fastening of the tension device (fig. Bolts of fastening of a casing of a belt see).
4. To remove a gear belt.
5. To remove from a cam-shaft a pulley and a basic plate of longitudinal installation.
6. To remove a sealing ring of a cam-shaft by means of the adaptation 21.008 And.
7. To oil a new sealing ring of a cam-shaft, to establish it in the adaptation 21.009 And and to press a ring into a head of the block of cylinders.
8. To establish on a cam-shaft a basic plate and a pulley.
9. To dress a gear belt, to establish on labels cranked and distributive shaft (fig. Adjusting signs on system timing see).
10. To pull a gear belt by means of the tension device (fig. engine ONS Knots see).
11. To establish a casing of a gear belt.
12. To connect to a radiator elastic pipelines of system of cooling (top and bottom).
13. To fill system of cooling with a liquid and to remove from it air.
14. To connect to the accumulator a weight wire.

CAM-SHAFT AND INSTALLATION ГАЗОРАСПРЕДЕЛЕНИЯ

Removal and installation

These actions are described in subsection 4.1.5.2.