Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
       4.1.4. Fuel system
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
      - 4.1.14. Cooling system
         4.1.14.1. Plums of a liquid and filling of system of cooling
         4.1.14.2. Removal and radiator installation
         4.1.14.3. Removal and fan installation
         4.1.14.4. The pump охладжающей liquids
         4.1.14.5. Thermostat replacement
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.14. Cooling system

4.1.14.1. Plums of a liquid and filling of system of cooling

Plums of a cooling liquid

PERFORMANCE ORDER
1. To disconnect from the accumulator a weight wire.
2. To place under the car pure capacity for plum of a cooling liquid from cooling system.
3. To unscrew a stopper plum in the block of cylinders and to disconnect the bottom elastic pipeline from a radiator.

Filling of system of cooling

PERFORMANCE ORDER
1. To screw up a stopper plum in the block of cylinders and to connect the bottom elastic pipeline to a radiator.
2. To fill cooling system through a jellied aperture of a broad tank with recommended quantity of a cooling liquid.
3. To connect the accumulator.
4. To start the engine and to allow to it to work with number of turns of the accelerated idling before opening of the valve of the thermostat.
5. To switch off the engine and to check up tightness of connections of system of cooling.
6. After engine cooling to check up and in case of need to add level of a cooling liquid.