Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
         - 4.1.4.1. Carburettor Ford with changeable section диффузора
            4.1.4.1.1. Removal and carburettor installation
            4.1.4.1.2. Dismantling, check and carburettor assemblage
            4.1.4.1.3. Adjustment of number of turns of idling of the engine and the maintenance WITH
            4.1.4.1.4. Starting arrangement adjustment
            4.1.4.1.5. Adjustment of a cable throttle заслонки
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. A diaphragm of a vacuum regulator
          4.1.4.2. Carburettor Weber 32/36 DGAV
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.4.1.1. Removal and carburettor installation Removal

PERFORMANCE ORDER
1. To remove the air filter.
2. To disconnect from the carburettor elastic the pipeline: fuel and heating givings (a liquid cooling the engine) the automatic starting arrangement and to close their apertures corresponding заглушками.
3. To disconnect from the carburettor a socket of an electric wire of the electromagnetic valve.
4. To disconnect from the lever throttle заслонки a cable of a pedal of an accelerator.
5. To unscrew nuts of fastening of the carburettor to an inlet collector and to remove them together with washers.
6. To remove the carburettor from an inlet collector to cover with rags an aperture of an inlet collector.

Installation

PERFORMANCE ORDER
1. Actions on carburettor installation are carried out in sequence of return to process of its removal.
2. After carburettor installation it is necessary to adjust a cable of a pedal of an accelerator, to remove air from system of cooling and to adjust number of turns of idling and the maintenance WITH (mix structure).