Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
       4.1.4. Fuel system
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.1.6. Removal and engine installation
Removal

PERFORMANCE ORDER

1. To disconnect from the accumulator a weight wire.

2. To remove a cowl.

3. To remove the air filter.

4. To merge cooling liquid from cooling system (to disconnect pipelines from a radiator, a broad tank, the case of the automatic starting arrangement of the carburettor, and also a heater).

5. To disconnect electric wires from the generator, the gauge of temperature of a cooling liquid and the gauge of pressure of oil.

6. To remove from the distributor of ignition the high voltage distributor together with wires.

7. To disconnect from the ignition distributor a multicontact socket.

8. To disconnect from the carburettor a cable of a pedal of an accelerator.

9. To disconnect from the carburettor fuel and vacuum hoses, and also electric wires.

10. To remove клиновой a belt and the auxiliary pump of system of a steering (if is present at the given version). To suspend the auxiliary pump to a body of the car by means of a soft wire.

11. To unscrew a forward reception pipe from a final collector.

12. To establish таль for engine lifting (the adaptation 21.068) and to raise the engine, and then to unscrew holders of the engine.

13. To unscrew the bolts connecting the engine with a transmission

14. To disconnect electric wires and to remove a starter.

15. To disconnect from the engine a weight wire.

16. To remove the holder located between the engine and a transmission.

17. To prop up a transmission by means of the corresponding lift and a wide board and a few to raise a transmission.

18. To take cautiously engine, taking at first arms of its fastening to a body cross-beam.

Installation

PERFORMANCE ORDER

1. Engine installation is carried out in return sequence in relation to removal process.

2. To oil шлицов a shaft of coupling of a transmission before connection of these knots.

3. To establish a new lining of a forward exhaust pipe.

4. To fill system of cooling with a corresponding liquid and to remove air from cooling system.

5. To check up and in case of need to adjust a corner of an advancing of ignition, and also number of turns of the engine idling and concentration WITH in exhaust gases.