Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
         - 4.1.4.1. Carburettor Ford with changeable section диффузора
            4.1.4.1.1. Removal and carburettor installation
            4.1.4.1.2. Dismantling, check and carburettor assemblage
            4.1.4.1.3. Adjustment of number of turns of idling of the engine and the maintenance WITH
            4.1.4.1.4. Starting arrangement adjustment
            4.1.4.1.5. Adjustment of a cable throttle заслонки
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. A diaphragm of a vacuum regulator
          4.1.4.2. Carburettor Weber 32/36 DGAV
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.4.1.5. Adjustment of a cable throttle заслонки
THE GENERAL DATA

Fastening of a cable throttle заслонки

And – an adjusting nut

PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. To press against the stop a pedal of an accelerator and to fix it in this position.
3. An adjusting nut to establish in position at which the control mean the carburettor is in position of full giving of fuel.
4. Whether to release and repeatedly to press a pedal of an accelerator and to check up is available люфт in a direction of increase in opening throttle заслонки. At presence люфта, adjustment to repeat.
5. To establish the air filter and to connect the accumulator.