Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
- 4.1. Petrol engines
4.1.1. Technical characteristics
4.1.2. Adjustment of backlashes of valves
- 4.1.3. Ignition system
4.1.3.1. The gauge of impulses with the Hall converter
4.1.3.2. To distribute ignitions
4.1.3.3. The switchboard
4.1.3.4. Remarks on operation
4.1.3.5. Installation of a corner of an advancing of ignition
4.1.3.6. Definition of malfunctions
4.1.3.7. Removal and installation of the distributor of ignition
4.1.4. Fuel system
4.1.5. The repair which is not demanding removal of the engine
4.1.6. Removal and engine installation
4.1.7. Engine dismantling
4.1.8. Identification of co-operating parts
4.1.9. Engine assemblage
4.1.10. Replacement of pistons
4.1.11. Removal and installation of an intermediate shaft
4.1.12. System timing
4.1.13. Greasing system
4.1.14. Cooling system
4.1.15. A suspension bracket of the power unit
4.1.16. System of release of the fulfilled gases
4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment
|
System of ignition Lucas
|
|
1 – the coil of ignition,
2 – the switchboard of ignition,
3 – the case of the distributor of ignition,
4 – приводная a gear wheel,
5 – a shaft of the distributor of ignition,
6 – the gauge of the Hall,
7 – a rotor of the gauge,
8 – a rotor of the distributor,
9 – a cover of the distributor of ignition |
Removal
| PERFORMANCE ORDER |
| 1. To disconnect the accumulator from a car electric equipment. |
| 2. To disconnect wires of a high voltage from свеч ignition and the distributor and to remove the high voltage distributor. |
| 3. To establish the piston of 1st cylinder in ВМТ. For this purpose it is necessary to rotate a hand a cranked shaft of the engine before position in which the distributor rotor will be established opposite to contact of 1st cylinder in the distributor of a high voltage of the distributor of ignition. |
| 4. To designate this position of a rotor of the distributor concerning the case of the distributor of ignition for simplification of the further installation of the distributor of ignition. |
| 5. To unscrew a bolt of fastening of the case of the distributor of ignition and to remove the ignition distributor. |
|
Installation
| PERFORMANCE ORDER |
| 1. To check up, whether there is a piston of 1st cylinder in ВМТ (combination of a corresponding sign on a pulley with a constant sign (fig. Control signs for installation of a corner of an advancing of ignition of ignition see). |
| 2. To insert the ignition distributor into an aperture in the block of cylinders of the engine, to insert a bolt of fastening of the distributor of ignition, but not to tighten it. |
| 3. To check up sign combination on the case of the distributor with position of a rotor of the distributor, corresponding to position opposite to contact of 1st cylinder of the distributor of a high voltage. |
| 4. To connect high voltage wires to spark plugs and the high voltage distributor. |
| 5. To connect the accumulator to a car electric equipment. |
| 6. To establish a corner of an advancing of ignition by means of a stroboscopic lamp (subsection 4.1.3.5 see). |
|
|
|