Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
      - 4.1.3. Ignition system
         4.1.3.1. The gauge of impulses with the Hall converter
         4.1.3.2. To distribute ignitions
         4.1.3.3. The switchboard
         4.1.3.4. Remarks on operation
         4.1.3.5. Installation of a corner of an advancing of ignition
         4.1.3.6. Definition of malfunctions
         4.1.3.7. Removal and installation of the distributor of ignition
       4.1.4. Fuel system
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment


4.1.3.5. Installation of a corner of an advancing of ignition
THE GENERAL DATA

Control signs for installation of a corner of an advancing of ignition of ignition

1 – a constant sign,

2 – sign ВМТ of the piston of 1st cylinder on a pulley

PERFORMANCE ORDER
1. To connect a stroboscopic lamp according to the instruction on its operation.
2. To disconnect the vacuum pipeline from the distributor ignitions (distributor Bosch).
3. To start the engine, to warm up it and to leave idling. To check up value of number of turns of idling of the engine.
4. To check up a corner of an advancing of ignition, directing a lamp on a pulley.
5. In case of definition of size of a corner of an advancing of ignition not corresponding to requirements to weaken fastening of the distributor of ignition and, turning it in a corresponding direction, to expose a sign on correct size of a corner of an advancing of ignition with a constant sign 1. In engines ONS deeper notches on a pulley flange are located through 4 , and small notches are in their axis of symmetry (allowing to establish a corner multiple 2 ).
6. To fix the distributor of ignition and to check up installation of a corner of an advancing of ignition.