Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
- 7. A kardannyj shaft and the back bridge
   7.1. Technical characteristics
   7.2. Removal and installation карданного a shaft
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assemblage of the back bridge
   7.6. Dismantling and differential assemblage
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assemblage and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
   - 7.11. Semiaxes
      7.11.1. Removal and installation
      7.11.2. Dismantling and assemblage
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



7.11.2. Dismantling and assemblage
PERFORMANCE ORDER
1. To remove collars of fastening of protective casings of hinges of a semiaxis.
2. To cut a casing of hinges and to unbend them with the help пассатижей.
3. By means of the adaptation for compression of springs to remove a nave of a semiaxis from the hinge.
4. To remove an external lock ring of the three-humeral hinge and to designate its position concerning a semiaxis.
5. To move a protective casing along a semiaxis and by means of a stripper with three captures to remove the hinge.
6. To remove a lining from an artificial material, a casing and a rubber protective casing of the hinge.
7. To take a rubber ring of round section from a nave.
8. To clear and check up all details, to replace worn out or damaged.
9. To establish on полуось protective a casing, a casing and a lining from an artificial material (a convex surface directed from the hinge).
10. By means of the plug of the corresponding sizes to establish on полуось the three-humeral hinge. Both hinges of a semiaxis should be displaced from each other on a corner 60 (using the designations made during dismantling).
11. To establish a lock ring.
12. By means of the adaptation for compression of springs to establish a semiaxis nave on the hinge. To fill the hinge in 15 grammes of firm greasing.
13. To establish on a nave a rubber ring of round section.
14. By means of a corresponding stripper to establish a casing of the three-humeral hinge, having its edge in hinge flutes.
15. To clamp a casing on all perimetre.
16. To fill hinges in 65-85 grammes of firm greasing S-MIC 75 F or SQM-IC 9004.
17. To establish rubber protective a casing and to clamp new collars of fastening of casings.