| 1. To establish flanges (8, fig. the Back bridge see) adjustments of a backlash of bearings of a box of differential without linings of round section. |
| 2. To establish the oiled bearings of a box of differential, and also replacing box of differential. |
| 3. To screw up a hand flanges of adjustment of a backlash of bearings of a box of differential before their contact to bearings and to tighten накатанную a nut of fixing of a replacing box. |
| 4. To turn repeatedly replacing box for exact packing of rollers of bearings. |
| 5. To establish the indicator of hour type on картере, and its measuring tip to rest against the middle of a replacing box. |
| 6. To execute one complete revolution of a replacing box and to observe of fluctuations of an arrow of the indicator. |
|
7. To establish replacing box in position in which the arrow of the indicator costs on the average position between extreme indications. Replacing box not to rotate any more. |
|
8. To establish the indicator of hour type on the holder (the adaptation 15.008). To rest its measuring tip against a template of the adaptation 15.075 and to adjust the indicator. For the bridge 6,5 "to use the bottom plane of a template, and for the bridge 7" – the top plane. |
| 9. To rest the holder of the indicator against an end face of a gear wheel of the main transfer, and a measuring tip of the indicator in the middle of a replacing box. |
| 10. To remove a difference concerning the distance established according to a template. |
| 11. To correct the measured distance, selecting a thickness of a lining between the internal bearing of a leading gear wheel and a gear wheel of the main transfer so that the deviation from the zero indication of the indicator made no more than 0,01 mm. |
| 12. After a tightening of a nut of fastening of bearings of gear wheels, it follows зачеканить. |
| 13. By means of the adaptation 15.047 And to establish a new sealing ring of a gear wheel of the main transfer. |
| 14. To establish a flange of a gear wheel of the main transfer (for connection with the back hinge карданного a shaft) and to tighten a nut of fastening of a flange the corresponding moment. |