Ford Sierra


Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
- 7. A kardannyj shaft and the back bridge
   7.1. Technical characteristics
   7.2. Removal and installation карданного a shaft
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assemblage of the back bridge
   7.6. Dismantling and differential assemblage
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assemblage and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
    7.11. Semiaxes
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



7.7. Adjustment of bearings of gear wheels of the main transfer
THE GENERAL DATA

Leading gear wheel of the main transfer together with conic bearings and the deformed remote plug

 1 – the external conic bearing,

2 – the deformed remote plug.

PERFORMANCE ORDER
1. By means of adaptations 15.033 and 15.074 to take an external ring of the external bearing of a gear wheel of the main transfer from картера the back bridge (in case of the bridge 6,5 "to use the aligning adaptation 15.068).
2. To establish a new external ring of the external bearing of a gear wheel of the main transfer by means of the adaptation 15.033.
3. To take in the same way an external ring of the internal bearing.
4. To establish a new external ring of the internal bearing together with a new lining in the thickness of 2 mm by means of the adaptation 15.083 (and also adaptations 15.068 in case of the bridge 6,5 ").
5. By means of a corresponding stripper to remove the internal conic bearing (an internal ring and rollers) from a gear wheel of the main transfer and to remove the remote plug.
6. To establish the new internal conic bearing together with the new lining in the thickness of 1 mm located between the bearing and a gear wheel of the main transfer.
7. To oil conic bearings of a gear wheel for transmissions.
8. To insert a gear wheel in картер, to establish on a gear wheel the remote plug and the external conic bearing.
9. To screw up a nut of fastening of bearings and to tighten it by means of bent накидного a key of 36 mm and adaptations 15.073. During a tightening of a nut by means of a dynamometer 15.041 placed in the adaptation 15.073, it is necessary to measure the moment of resistance of rotation of a gear wheel of the main transfer.
10. The nut of fastening of bearings should be tightened so that to achieve the necessary moment of resistance of turn of a gear wheel (subsection 7.1 see).