Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
          4.1.4.1. Carburettor Ford with changeable section диффузора
         - 4.1.4.2. Carburettor Weber 32/36 DGAV
            4.1.4.2.1. Removal and carburettor installation
            4.1.4.2.2. Adjustment of position of a float
            4.1.4.2.3. Adjustment starting заслонки
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the maintenance WITH
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.1.4.2.4. Check and adjustment of the automatic starting arrangement

THE GENERAL DATA

Position of elements of management starting заслонками at adjustment of the automatic starting arrangement of carburettor Weber

And – a drill, In – a plate

PERFORMANCE ORDER

1. Partially to open throttle заслонку mixes and to turn a cam of the accelerated idling so that the adjusting screw has concerned its tops.

2. To release a pedal of an accelerator and to block a cam in this position.

3. To close starting заслонку while the cam emphasis will not rest against the adjusting screw of the accelerated idling.

4. Holding starting заслонку in the closed position, to measure width of a backlash between edge throttle заслонки and a wall of the air chamber. For measurement to use a core or a drill of the corresponding diameter.

5. In case of inappropriate size of a backlash to adjust it, pressing a plate ().

Adjustment of the raised number of turns of idling of the engine

PERFORMANCE ORDER

1. To connect to the engine a tachometre.

2. To warm up the engine to normal working temperature and to release an accelerator pedal.

3. At the working engine to adhere starting заслонку in vertical position (full opening) and to turn the lever of the starting arrangement to its delay the mechanism of the accelerated idling.

4. To measure number of turns of the engine and in case of need to adjust it by turn of the adjusting screw of number of turns of the accelerated idling.