Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
          4.1.4.1. Carburettor Ford with changeable section диффузора
         - 4.1.4.2. Carburettor Weber 32/36 DGAV
            4.1.4.2.1. Removal and carburettor installation
            4.1.4.2.2. Adjustment of position of a float
            4.1.4.2.3. Adjustment starting заслонки
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the maintenance WITH
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.4.2.2. Adjustment of position of a float
THE GENERAL DATA

Adjustment of position of a float of carburettor Weber

And = 41 0,5 mm.


PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. To disconnect from the carburettor the pipeline of giving of fuel.
3. To pick up a screw-driver a clamp and to disconnect draught of management starting throttle заслонкой from the lever of an axis starting throttle заслонки.
4. To unscrew six screws and to uncover the carburettor.
5. To establish a carburettor cover vertically with a float directed downwards.
6. To measure distance from the bottom surface of a float to a plane of a cover without a lining. It should make 41�0,5 mm. In case of need to adjust it, bending down a plate on the top surface of a float.
7. To establish a carburettor cover together with a new lining.
8. To connect the pipeline of giving of fuel and draught of management air заслонкой.