Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
          4.1.4.1. Carburettor Ford with changeable section диффузора
         - 4.1.4.2. Carburettor Weber 32/36 DGAV
            4.1.4.2.1. Removal and carburettor installation
            4.1.4.2.2. Adjustment of position of a float
            4.1.4.2.3. Adjustment starting заслонки
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the maintenance WITH
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



4.1.4.2.1. Removal and carburettor installation

Removal

PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. Being careful, to unscrew a stopper of a broad tank.
3. From the starting arrangement to remove hoses of a cooling liquid and to muffle them.
4. To disconnect a cable of management throttle заслонкой.
5. To remove a hose of giving of fuel to the carburettor.
6. To remove from the carburettor a vacuum hose from the ignition distributor.
7. To unscrew 4 fixing nuts and to remove the carburettor.
8. An aperture of an inlet collector to close rags.

Installation

PERFORMANCE ORDER
1. Carburettor installation is made in sequence of return to removal.
2. After installation it is necessary to check up: level of a cooling liquid and the maintenance окиси carbon and also to adjust idling turns.