Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
      - 4.1.4. Fuel system
          4.1.4.1. Carburettor Ford with changeable section диффузора
         - 4.1.4.2. Carburettor Weber 32/36 DGAV
            4.1.4.2.1. Removal and carburettor installation
            4.1.4.2.2. Adjustment of position of a float
            4.1.4.2.3. Adjustment starting заслонки
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the maintenance WITH
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.1.4.2.5. Adjustment of number of turns of idling of the engine and the maintenance WITH

THE GENERAL DATA

Adjustment of idling of carburettor Weber

1 – the screw of adjustment of number of turns of the engine,

2 – a casing of the screw of adjustment of structure of a mix

PERFORMANCE ORDER

1. To warm up the engine to normal working temperature.

2. To connect the analyzer of exhaust gases and a tachometre according to instructions of the instruction on their application.

3. To keep in a current about 30 seconds number of turns of 3000 rpm, and then to release an accelerator pedal. To wait before installation of indications of the analyzer.

4. To check up number of turns of idling of the engine. In case of need to adjust number of turns of the engine by means of the screw (1).

5. To read indications of concentration WITH in exhaust gases. If concentration WITH small to remove a casing of the screw of adjustment of structure of a mix (2) and to adjust this screw concentration FROM idling engine.

6. Repeatedly to check up number of turns of idling of the engine and in case of need to adjust.