Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
      - 4.1.1. Technical characteristics
         4.1.1.1. A head of the block of cylinders
         4.1.1.2. The block of cylinders of the engine
         4.1.1.3. The Krivoshipno-shatunnyj mechanism
         4.1.1.4. System timing
         4.1.1.5. Greasing system
         4.1.1.6. Cooling system
         4.1.1.7. Fuel system
         4.1.1.8. Ignition system
         4.1.1.9. The tightening moments
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
       4.1.4. Fuel system
       4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment


Смотрите http://hydra-website.com официальная ссылка hydra.

4.1.1.5. Greasing system
THE GENERAL DATA

Greasing under pressure provides шестеренчатый the oil pump in which case is перепускной the valve.

The minimum pressure of oil (at temperature 80 ):
 – At 750 rpm:
0,1 МПа
 – At 2000 rpm:
0,25 МПа
Pressure of opening перепускного the valve (at 1000 rpm):
0,40 – 0,47 МПа
Pressure of fire of a control bulb of pressure of oil:
0,03 МПа – 0,06 МПа

The oil pump.

Шестеренчатый the oil pump, with an internal arrangement of teeths, type Hobourn-Eaton, is put in action from an intermediate shaft.

Backlash of a gear wheel with an internal arrangement of teeths concerning the case
0,150 – 0,301 mm.
Backlash between teeths of gear wheels
0,05 – 0,20 mm.

Axial backlash of gear wheels
0,028 – 0,104 mm.

The oil filter

Полнопроходной the oil filter is located on the left side of the block of cylinders.
Mark and type: Motorcraft EFL 90.