Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
- 9. Suspension brackets
   - 9.1. A forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assemblage of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
    9.2. A back suspension bracket
10. Brake system
11. A body
12. An electric equipment


9.1.8. Replacement of bearings of a nave of a forward wheel
THE GENERAL DATA

Nave of a forward wheel in a cut

1 – conic bearings,

2 – a sealing ring

PERFORMANCE ORDER
1. To remove a rotary fist of a wheel (the corresponding description in subsection 9.1.6 see).
2. To screw up nuts (conic surfaces outside) on bolts of fastening the wheels located in a nave, and to fix in vice rotary fist together with nave, holding for nuts of wheels.
3. To remove a protective cap of an axis of a wheel from the interior of a rotary fist.
4. To unscrew a nut of an axis of a wheel and to take a flat lining.
5. To take the internal conic bearing from a rotary fist.
6. To remove a rotary fist from a wheel nave.
7. To extend a sealing ring by means of the adaptation 21.051.
8. To beat out external rings of conic bearings by means of a core from bronze.
9. To clear and check up a technical condition of the taken details. To replace the worn out or damaged details.
10. To insert by means of the adaptation 14.024 new external rings of bearings into the rotary fist as which emphasis serves wooden брусок.
11. To fill all space between bearings firm greasing for bearings.
12. To establish the external bearing and to press a new sealing ring with space between sealing edges filled with firm greasing.
13. To establish a rotary fist on a wheel nave.
14. To establish the internal conic bearing, to insert a flat lining and to tighten new самоконтрящуюся a nut of a nave of a wheel the corresponding moment (subsection 9.1.1 see)
15. To establish a protective cap of an axis of a wheel from the interior of a rotary fist.
16. To remove a rotary fist from a vice and to unscrew nuts from bolts of fastening of a wheel.

17. To establish a rotary fist on the car.