Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
- 9. Suspension brackets
   - 9.1. A forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assemblage of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
    9.2. A back suspension bracket
10. Brake system
11. A body
12. An electric equipment

9.1.4. Removal and stabilizer installation
Removal

PERFORMANCE ORDER

1. To remove clamps and to unscrew 4 bolts of fastening of the stabilizer to a body.

2. To unscrew nuts of fastening of the stabilizer to the bottom cross-section levers of a suspension bracket, to take forward metal washers and forward rubber rings (fig. the Forward suspension bracket see).

3. To unscrew from both parties of a suspension bracket a nut of a bolt of fastening of the cross-section lever to an engine mount cross-beam.

4. To remove levers from a body and to take the stabilizer, to remove from the stabilizer back rubber rings and back metal washers.

Installation

PERFORMANCE ORDER

To establish the suspension bracket stabilizer, carrying out actions in return sequence in relation to removal process. Nuts of bolts of fastening of levers of a suspension bracket to an engine mount cross-beam should be tightened in two stages (subsection 9.1.1 see) only having lowered the car.