Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
- 9. Suspension brackets
   - 9.1. A forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assemblage of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
    9.2. A back suspension bracket
10. Brake system
11. A body
12. An electric equipment



9.1.2. Removal and installation of a rack of a forward suspension bracket
THE GENERAL DATA

Forward suspension bracket

1 – knot of the top fastening of a rack of a suspension bracket,
2 – the basic bearing,
3 – a spring of a suspension bracket,
4 – the shock-absorber,
5 – a rotary fist,
6 – the lever with the spherical hinge,
7 – the stabilizer,
8 – a nave of a wheel,
9 – bearings of a nave,
10 – a nut of a nave,
11 – заглушка,
12 – the metallo-rubber plug

Removal

PERFORMANCE ORDER
1. To weaken nuts of fastening of a wheel from the corresponding party of the car.
2. To lift and prop up in front of the car and to remove forward wheels.
3. By means of a jack to prop up the hinge of the cross-section lever.
4. To unscrew bolts of fastening of a rack of a suspension bracket to a rotary fist of a wheel.
5. Into cut of a rotary fist to insert the adaptation 14.026 and to turn it on 90 °, weakening the bottom fastening of a rack of a suspension bracket.
6. To press downwards a rotary fist the suspension bracket rack will not be released yet, paying attention not to damage a brake hose.
7. To suspend a rotary fist to a body so that it did not concern brake hoses.
8. In a motor compartment to unscrew a plastic casing of the top fastening of a rack of a suspension bracket.
9. Blocking a rod of the shock-absorber a key for шестигранных nests of 6 mm and holding a suspension bracket rack that it has not dropped out (it is necessary the help of other person), to unscrew a nut of the top fastening of a rack to a body.
10. To take in a direction downwards a suspension bracket rack

Installation

PERFORMANCE ORDER
1. To establish a suspension bracket rack on a corresponding place.
2. To insert the top lining and a nut of the top fastening of a rack of a suspension bracket.
3. To check up a centering of a rod of the shock-absorber concerning a body and to tighten a nut of the top fastening, holding a rod with a key for шестигранных nests of 6 mm.
4. To insert the adaptation 14.026 into a groove of a rotary fist and to turn it on 90 °.
5. To establish the bottom part of a rack in a rotary fist.
6. To remove the adaptation 14.026.
7. To screw up a bolt of fastening of a rack to a rotary fist of a wheel and to tighten its corresponding moment.
8. To screw wheels, to lower the car and to tighten nuts of wheels the corresponding moment.
9. To check up a convergence of forward wheels.