Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
- 9. Suspension brackets
   - 9.1. A forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assemblage of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
    9.2. A back suspension bracket
10. Brake system
11. A body
12. An electric equipment

9.1.6. Removal and installation of a rotary fist

THE GENERAL DATA

Fastening of a rotary fist of a wheel

1 – a bolt of the bottom fastening of the shock-absorber,

2 – a nut of fastening of steering draught,

3 – a nut of fastening of the stabilizer

Removal

PERFORMANCE ORDER

1. To weaken from the corresponding party of a nut of a forward wheel.

2. To lift and prop up the car and to remove a forward wheel.

3. To remove a support of a brake without a detachment of hydraulic pipelines and to suspend it to a body by means of a soft wire.

4. To unscrew the screw of fastening of a brake disk and to remove a disk.

5. To take шплинты and to unscrew корончатые nuts of spherical hinges from a rotary fist.

6. To squeeze out from a rotary fist the spherical hinge of steering draught by means of the adaptation 13.006.

7. To squeeze out the spherical hinge of the cross-section lever from a rotary fist by means of a stripper.

8. To unscrew from a rotary fist tightening a bolt of the bottom fastening of a rack of a suspension bracket.

9. To disconnect a rack of a suspension bracket from a rotary fist by means of the adaptation 14.026 and to take a rotary fist.

Installation

For installation of a rotary fist it is necessary to execute actions in return sequence in relation to removal process.