Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
- 9. Suspension brackets
    9.1. A forward suspension bracket
   - 9.2. A back suspension bracket
      9.2.1. Technical characteristics
      9.2.2. Shock-absorber replacement
      9.2.3. Replacement of a spring of a suspension bracket
      9.2.4. Removal and installation of the lever of a suspension bracket
      9.2.5. Replacement of the metallo-rubber plug of a beam of a suspension bracket
      9.2.6. Replacement of bearings of a nave of a back wheel
10. Brake system
11. A body
12. An electric equipment


9.2.6. Replacement of bearings of a nave of a back wheel
THE GENERAL DATA

Nave of a back wheel


1 – a nave,

2 – a lining,

3 – a nut


PERFORMANCE ORDER
1. To remove a protective cap of a back wheel and to weaken nuts of fastening of a wheel.
2. To weaken a nave nut on the semiaxis end.
3. To lift and fix a back part of the car, to remove a corresponding wheel.
4. To remove a brake drum (subsection 10.3 see).
5. To unscrew a nave nut on the semiaxis end.
6. By means of a stripper with external captures to remove a wheel nave.
7. To remove from within a bearing brake board a plastic casing external приводного the hinge of a semiaxis after a raising a screw-driver of tightening rings on heads of bolts and unscrewing of bolts of fastening of a casing.
8. To unscrew and take four bolts of fastening of the case of bearings of a nave of a wheel to the lever of a suspension bracket and to take the case of bearings of a nave of a back wheel.
9. To screw in freely two bolts of fastening (on a diagonal) cases of bearings of a nave after its extraction for deduction of a bearing brake board and preservation of a back brake hose.
10. To take from the case of bearings of a nave of a wheel two sealing rings, and also conic bearings (external and internal).
11. To beat out external rings of bearings a core from bronze.
12. To clear an internal surface of the case of bearings of a nave of a wheel.
13. To establish in the case by means of the adaptation 14.019 external rings of bearings.
14. To grease with greasing space between bearings and to insert into the case conic bearings.
15. To insert into the case sealing rings by means of the adaptation 14.019.
16. To unscrew two bolts holding bearing board of a brake, and to insert the case of bearings of a nave of a wheel into bearing board of a brake.
17. To screw up bolts of fastening of the case of bearings to the lever of a suspension bracket and to tighten their corresponding moment.
18. To establish a plastic casing external приводного the semiaxis hinge.
19. To insert a nave flange on полуось, to put on on полуось a lining and to screw up a new nut without a definitive tightening.
20. To establish a brake drum.
21. To put on a wheel, to screw up nuts of fastening of a wheel and to lower the car.
22. To tighten the corresponding moment a nut of a nave of a wheel on the end of a semiaxis and to fix its stamping of a cylindrical part of a nut by a steel punch in a carving flute.
23. To tighten the corresponding moment of a nut of fastening of a wheel.