Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
- 10. Brake system
   10.1. Technical characteristics
    10.2. Forward brakes
   - 10.3. Back brakes
      10.3.1. Removal and drum installation
      10.3.2. Replacement brake колодок
      10.3.3. Cylinder replacement
   10.4. Removal and installation of the main brake cylinder
   10.5. Removal of air from brake system
   10.6. Adjustment of a manual brake
11. A body
12. An electric equipment

10.3. Back brakes

10.3.1. Removal and drum installation

Back brake DBA


1 – a brake drum,
2 – brake колодки,
3 – a bearing board,
4 – the cylinder,
5 – the lever of a manual brake,
6 – a latch of the mechanism of automatic adjustment of a backlash колодок,
7 – a returnable spring колодок

Hook of a spring of a conductor колодки

The hook of a spring of a conductor колодки – is specified by an arrow.

1. To weaken nuts of fastening of a back wheel.
2. To lift and fix a back part of the car, to remove a back wheel.
3. To remove from wheel bolts (if there are) clamps of a brake drum after easing of their fastening by chisel blows (turn to the left).
4. To check up, whether the manual brake is switched off.
5. To remove a brake drum from a wheel nave.


Installation of a back brake

1 – a returnable spring колодок,

2 – fastening of a spring of a conductor колодки,

3 – a latch of automatic adjustment of a backlash

1. To check up, damages and deterioration of a brake drum, and also whether the working surface of a drum of the deepenings felt as fingers has. In case of need переточить a drum or to replace it.
2. To clear mechanism interiors, having blown its compressed air.
3. To establish a brake drum on a flange of a nave of a wheel.
4. To establish a back wheel.
5. To lower the car and to tighten nuts of fastening of a wheel the corresponding moment.