Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
   - 4.1. Petrol engines
       4.1.1. Technical characteristics
      4.1.2. Adjustment of backlashes of valves
       4.1.3. Ignition system
       4.1.4. Fuel system
      - 4.1.5. The repair which is not demanding removal of the engine
         4.1.5.1. Removal and installation of a gear belt
         4.1.5.2. Removal of a head of the block of cylinders
         4.1.5.3. Dismantling and assemblage of a head of the block of cylinders
         4.1.5.4. Installation of a head of the block of cylinders
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of co-operating parts
      4.1.9. Engine assemblage
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System timing
      4.1.13. Greasing system
       4.1.14. Cooling system
      4.1.15. A suspension bracket of the power unit
      4.1.16. System of release of the fulfilled gases
    4.2. The diesel engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.1.5.2. Removal of a head of the block of cylinders

THE GENERAL DATA

Knot of the air filter

1 – the case,

2 – a cover,

3 – a filtering element,

4 – the goffered hose of an air inlet,

5 – an air inlet of warm air

PERFORMANCE ORDER

1. To disconnect from the accumulator a weight wire.

2. To merge cooling liquid from cooling system (to unscrew a stopper on the right side of the block of cylinders and also to disconnect the bottom elastic pipeline from a radiator).

3. To remove the air filter, to disconnect the pipeline and draught from the carburettor and an inlet collector.

4. To disconnect electric wires from the carburettor and a head of the block of cylinders.

5. To disconnect from свеч ignitions of a wire of a high voltage and to remove the high voltage distributor.

6. To disconnect pipelines of a cooling liquid from the chamber of the starting arrangement of the carburettor, the top hose from a radiator, and also a hose of a broad tank from a head of the block of cylinders.

The prevention
It is not necessary to have a head of the block of cylinders the bottom plane on a horizontal surface as it threatens with damage of valves acting below a plane. A head of the block of cylinders it is necessary to have so that plates of valves concerned nothing.