Ford Sierra

1.9. Replacement of bulbs

THE GENERAL DATA

Bulbs of near and far light

Bulbs of near and far light, and also dimensional fires are accessible from outside a motor compartment.

PERFORMANCE ORDER

1. To remove a casing from a back part of a headlight, turning it counter-clockwise. 2. To disconnect a socket of electric wires (). 3. To remove a spring of fastening of a bulb (). 4. To turn the holder of a bulb counter-clockwise and to take it from a headlight. 5. To replace a bulb. 6. To insert the holder of a bulb into a nest of a headlight and to fix its turn against the stop to the right. 7. To establish a spring of fastening and a socket of wires. 8. To check up correctness of functioning of a bulb. 9. To fix a casing on a back part of a headlight. The prevention It is impossible to touch fingers a glass part of bulbs, in particular галогенных. Otherwise before bulb installation in its nest it is necessary to wash out spirit a solution.

Dimensional fires

PERFORMANCE ORDER

1. To remove a casing from a back part of a headlight. 2. To take the holder of a bulb (under the holder of a bulb of near and far light). 3. To replace a bulb. 4. To insert the holder into a nest. 5. To be convinced that the bulb cartridge is well fixed. 6. To check up installation and bulb functioning. 7. To fix a casing on a back part of a headlight.

Bulbs of headlights of a headlight

Some versions of cars are equipped by headlights of a headlight with галогенными bulbs.

PERFORMANCE ORDER

1. To remove скобу () fastenings of a cover and to uncover headlights. 2. To compress a spring () fastenings of a bulb and to remove it. To take a bulb (). 3. To disconnect a socket of wires. 4. To connect a new bulb to a socket of electric wires and to insert it into a headlight. 5. To establish a spring of fastening of a bulb. 6. To establish a cover and скобу fastenings.

Forward indexes of turns

PERFORMANCE ORDER

1. From the back party of a bumper to remove outside a fastening clip. 2. To get from a bumper a bulb of the forward index of turn forward; in version Ghia the bulb of the forward index of turn adheres the lever located under the top fastening of a bumper which should be removed outside for bulb extraction. 3. To turn the holder of a bulb of the forward index of turn to the left and to take it. 4. To press a bulb, to turn it to the left and to take. 5. To establish in the holder a new bulb, turning it to the right, and then to fix the turn index, carrying out the above described actions in return sequence.

Back lantern

Bulbs of a back lantern are located in the knot of the holder accessible from within of a luggage carrier.

PERFORMANCE ORDER

CARS WITH THE BODY OF TYPE BERLIN AND THE SEDAN 1. To take knot of the holder, moving a fastening stopper located on the end of this knot. 2. In each knot of the holder four bulbs are located: a bulb of a signal of braking (1), a bulb of a backing (2), a bulb of dimensional fire and a back antifog lantern (3) and a bulb of the back index of turn (4). 3. To press a bulb which should be replaced, turn it and take from knot of the holder. 4. To establish a new bulb in knot of the holder, to turn it, and then to press knot of the holder before blocking of a stopper of fastening. CARS WITH THE BODY OF TYPE КОМБИ 1. Having opened a luggage carrier by means of a screw-driver to turn a stopper of fastening and to remove a casing of a back lantern. 2. To remove plates of fastening of knot of the holder () and to take it. In each knot of the holder five bulbs are located: a bulb of a backing (1), a bulb of dimensional back fire (2), a bulb of the back index of turn (3), a bulb of a back antifog lantern (4), a bulb of the alarm system of braking (5). 3. To press a bulb which should be replaced, turn it and take from knot of the holder. 4. To establish a new bulb in knot of the holder, to turn it, and then to fix knot of the holder.

Licence plate illumination

PERFORMANCE ORDER

1. By means of a thin screw-driver cautiously to take knot of a lamp of illumination of licence plate from a nest in a back bumper. 2. To turn to the left and to take the holder of a bulb. 3. To replace a bulb which is pressed in the holder. 4. To establish the holder and to fix knot of a lamp of illumination of licence plate in a back bumper.

Luggage carrier illumination

And the Sedan is present at some versions of equipment of a body of type of a berlin a bulb of illumination of a luggage carrier.

PERFORMANCE ORDER

1. By means of a screw-driver cautiously to remove a bulb plafond. 2. Turning a cartridge counter-clockwise to take it from a lamp plafond, and then to get from it a bulb.

Lamps of illumination of salon

PERFORMANCE ORDER

1. Having established the switch in average position (the lamp is switched off). 2. By means of a screw-driver it is necessary to get a bulb cartridge, and then to take a bulb.