Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
- 10. Brake system
   10.1. Technical characteristics
    10.2. Forward brakes
   - 10.3. Back brakes
      10.3.1. Removal and drum installation
      10.3.2. Replacement brake колодок
      10.3.3. Cylinder replacement
   10.4. Removal and installation of the main brake cylinder
   10.5. Removal of air from brake system
   10.6. Adjustment of a manual brake
11. A body
12. An electric equipment

10.3.3. Cylinder replacement Replacement with removal колодок

PERFORMANCE ORDER

1. To remove a drum and brake колодки.

2. To disconnect from the cylinder the brake pipeline and to muffle its aperture a corresponding stopper.

3. To unscrew two bolts of fastening of the cylinder to a bearing board and to take the brake cylinder together with a sealing ring.

4. To establish the cylinder together with a new sealing ring and to tighten the corresponding moment two bolts of fastening of the cylinder to a bearing board.

5. To connect the brake pipeline and to tighten its nut the moment of 8 Nanometers.

6. To establish brake колодки and a drum.

7. To remove air from brake system.

8. Strongly to press a brake pedal some times, knock in the back brakes, meaning their regulation will not stop yet.

Replacement without removal brake колодок

PERFORMANCE ORDER

1. To remove a brake drum.

2. To unscrew the brake pipeline from the cylinder and to muffle the pipeline a corresponding stopper.

3. To stretch brake колодки so that the lever of adjustment of a backlash has removed колодки from the cylinder.

4. To unscrew two bolts of fastening of the cylinder to a bearing board and to take the brake cylinder together with a sealing ring.

5. To establish the cylinder together with a new sealing ring and to tighten the corresponding moment two bolts of fastening of the cylinder to a bearing disk.

Berlin 2,0 дм³ and комби

6. To weaken the lever of adjustment of a backlash, pressing a ledge of the lever a screw-driver in a direction to the cylinder.

Berlin 1,3 and 1,6 дм³

7. To press downwards a latch of adjustment of a backlash by means of a screw-driver, releasing thus the adjusting lever, pressing simultaneously back колодку (asynchronous) to the cylinder.

All types

8. To check up correctness of installation of the ends колодок in grooves of pistons of the brake cylinder.

9. To connect the brake pipeline and to tighten its nut the moment of 8 Nanometers.

10. To remove air from brake system.

11. Strongly to press a brake pedal some times, knock in the back brakes, meaning their regulation will not stop yet.