Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
- 6. Transmissions
    6.1. A mechanical four-speed transmission
    6.2. A mechanical five-speed transmission
   - 6.3. Automatic transmission Ford With 3
      6.3.1. Technical characteristics
      6.3.2. Service and repair
      6.3.3. Check of level of oil in a transmission
      6.3.4. Check and washing of hydrokinetic transfer
      6.3.5. Check of pressure of oil in a transmission operating time
      6.3.6. Test of an overload of the engine by hydrokinetic transfer
      6.3.7. Check in the course of movement
      6.3.8. Adjustment of a tape of a brake of forward planetary transfer
      6.3.9. Removal and transmission installation
      6.3.10. Removal and installation of a cable of the mechanism kick-down
      6.3.11. Removal and installation of the relay of safe start of the engine
      6.3.12. Malfunctions and methods of their elimination
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

6.3.7. Check in the course of movement

THE GENERAL DATA

At small speed of movement when the accelerator pedal is slightly pressed, and the lever of a gear change established in position "D", there should be a switching on 2nd transfer at speed of movement below 45 km / ч and on 3 at speed below 65 km / ч.

PERFORMANCE ORDER

1. To check up gear change process on more lowest (reduction) on pressing of a pedal of an accelerator against the stop (kick-down). Sizes of number of turns of the engine, corresponding to a gear change, are resulted in subsection 6.3.1.

2. In case of a gear change with 1st on 2nd and about 2nd on 3 at inappropriate numbers of turns of the engine it is necessary to check up, whether causes pressing of a pedal of an accelerator against the stop at speed of movement of the car of 75 km / ч and position "D" a reduction of transfer with 3 on 2nd.

3. In position "D" at speed of movement of 50 km / ч pressing of a pedal of an accelerator 3/4 its courses should cause switching of transfer with 3 on 2nd.

4. In position "D" at speed of movement of 90 km/h and at release to an accelerator pedal should насупить switching of transfer with 3 on 2nd, and in a range of speed of 75-25 km/h – switching from 3 transfers on 1st.

5. The mechanism of blocking of a transmission in position "Р" should provide car keeping on road with the big bias.