Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
- 6. Transmissions
    6.1. A mechanical four-speed transmission
    6.2. A mechanical five-speed transmission
   - 6.3. Automatic transmission Ford With 3
      6.3.1. Technical characteristics
      6.3.2. Service and repair
      6.3.3. Check of level of oil in a transmission
      6.3.4. Check and washing of hydrokinetic transfer
      6.3.5. Check of pressure of oil in a transmission operating time
      6.3.6. Test of an overload of the engine by hydrokinetic transfer
      6.3.7. Check in the course of movement
      6.3.8. Adjustment of a tape of a brake of forward planetary transfer
      6.3.9. Removal and transmission installation
      6.3.10. Removal and installation of a cable of the mechanism kick-down
      6.3.11. Removal and installation of the relay of safe start of the engine
      6.3.12. Malfunctions and methods of their elimination
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment


Experience the convenience of streaming on 123movies from any device.

6.3.6. Test of an overload of the engine by hydrokinetic transfer
THE GENERAL DATA

The engine should be started only at positions of the lever of a gear change "Р" and "N". At the engine idling, installation of the lever of a gear change in one of positions "R", "D", "2" or "1" should cause easy jerk of the car.

At increase in number of turns of the engine in position "D" or "R" and the pressed pedal of a brake or the tightened lever of a manual brake the engine should work with number of turns no more, than 2600 about / minute This test should not proceed more than 5 seconds. Pressure sizes at control number of turns also are idling resulted in the corresponding table in subsection 6.3.1.