Ford Sierra

Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
- 4. Engines
    4.1. Petrol engines
   - 4.2. The diesel engine
      - 4.2.1. Technical characteristics
         4.2.1.1. The block of cylinders
         4.2.1.2. The Krivoshipno-shatunnyj mechanism
         4.2.1.3. Greasing system
         4.2.1.4. Fuel system
         4.2.1.5. The tightening moments
      4.2.2. Check and adjustment of backlashes of valves
       4.2.3. Fuel system
       4.2.4. Atomizers
      4.2.5. Candles накаливания
      4.2.6. Compression check
      4.2.7. Removal of air from fuel system
      4.2.8. The fuel filter
      4.2.9. The fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
       4.2.11. The repair which is not demanding removal of the engine
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment

4.2.1.5. The tightening moments

THE GENERAL DATA

Bolts of fastening of a head of the block of cylinders

  – Engines to number SH 79876:

  • 1st stage
30 Nanometers

  • 2nd stage
70 Nanometers

  • 3rd stage
To unscrew on 1/4 turns

  • 4th stage
80 Nanometers

  – Engines from number SH 79876:

  • 1st stage
30 Nanometers

  • 2nd stage
70 Nanometers

  • 3rd stage
To unscrew on 1/4 turns

  • 4th stage
70 Nanometers; then to start the engine and to keep its work without loading within 10 minutes at 3000 rpm, and then to leave the engine before cooling a minimum at 3,5 o'clock

  • 5th stage
To tighten on 120 °

Covers of radical bearings
100 – 120 Nanometers.

Covers of rods
53 – 63 Nanometers.

Flywheel:

  – 1st stage
20 Nanometers

  – 2nd stage
100 Nanometers

Pulley of a cranked shaft
240 – 260 Nanometers

Holders of an axis of the lever of valves
17,5 – 2,5 Nanometers.

Candles накаливания
20 – 40 Nanometers.

Atomizers
90 Nanometers

Эксцентриковое the tension device приводной system chains timing
27,5 Nanometers

Fuel pipelines
30 – 35 Nanometers

Inlet and final collectors
20 – 25 Nanometers

Cover of a head of the block of cylinders
3 Nanometers