Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
- 12. An electric equipment
   12.1. Technical characteristics
   12.2. The relay and safety locks
   12.3. Removal and generator installation
   12.4. Dismantling and generator assemblage
   12.5. Tension adjustment клинового a belt
   12.6. A starter
   12.7. A windscreen screen wiper, knot of indexes and a headlight
   12.8. Removal and installation of a combination of devices
   12.9. Adjustment of light of headlights
    12.10. Heating and ventilation system
    12.11. Electroschemes



12.3. Removal and generator installation
THE GENERAL DATA

Generator removal

1 – connection of wires,


2 – the bottom bolts of fastening


Removal

PERFORMANCE ORDER
1. To disconnect a wire of weight from the accumulator, and also a socket of multicontact connection behind the generator (after removal of a safety fastener).
2. To weaken bolts of fastening of the generator.
3. To turn the generator to the engine and to remove клиновой a belt from a generator pulley.
4. To unscrew bolts of fastening and to take the generator.

Installation

PERFORMANCE ORDER
1. To insert the generator, to screw up bolts of its fastening and to tighten their hand.
2. To connect and fix a socket of multicontact connection of wires behind the generator.
3. To establish and pull клиновой a belt (1 – a bolt of the tension device, And – a belt deflection (And = 10 mm)).
4. To tighten a bolt of adjustment of a tightness, then a forward bolt of the bottom fastening and, at last, a back bolt of the bottom fastening of the generator.
5. To connect a weight wire to the accumulator.
6. To check up a tension клинового a belt. In case of need to weaken bolts of fastening of the generator, to pull клиновой a belt and again to tighten bolts, since a bolt of adjustment of a tightness, and then a bolt of forward and back fastening of the generator.