Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
6. Transmissions
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
- 12. An electric equipment
12.1. Technical characteristics
12.2. The relay and safety locks
12.3. Removal and generator installation
12.4. Dismantling and generator assemblage
12.5. Tension adjustment клинового a belt
12.6. A starter
12.7. A windscreen screen wiper, knot of indexes and a headlight
12.8. Removal and installation of a combination of devices
12.9. Adjustment of light of headlights
- 12.10. Heating and ventilation system
12.10.1. Removal and heater installation
12.10.2. The fan engine
12.11. Electroschemes
|
System of heating and car ventilation
|
|
1 – a heater,
2 – the case of a heater,
3 – air заслонки,
4 – knot of management,
5 – the case of the fan,
6 – fans
|
The heater case
|
|
1 – a nut of fastening,
2 – a heater,
3 – bells of giving of air
|
Removal
| PERFORMANCE ORDER |
| 1. To disconnect a wire of weight from the accumulator. |
| 2. In an engine compartment to establish spring clips on the elastic pipelines of a cooling liquid connected to a heater. |
| 3. To disconnect a cover and consolidations of air pipelines. |
| 4. To remove the average console of the forward panel together with a ware box (fastening by six bolts). |
| 5. To remove скобы a control lever heating on the forward panel and to unscrew the control lever case (three screws), to move it downwards and to disconnect electric wires. |
| 6. To disconnect from heating knot air bells. |
| 7. To disconnect on the left side two cables of management of giving of air. |
| 8. To unscrew nuts of fastening of knot of heating and to take it. |
|
Installation
| PERFORMANCE ORDER |
| For installation of knot of heating it is necessary to execute actions in return sequence in relation to removal process. Before installation of facing of a floor it is necessary to adjust a cable of management of giving of air. After heater installation it is necessary to remove air from system of cooling of the engine and to fill quantity of a cooling liquid to necessary level. |
|
|
|