Ford Sierra



Ford Sierra
1.2. Car identification
2. Maintenance service
3. The general data
4. Engines
5. Coupling
- 6. Transmissions
    6.1. A mechanical four-speed transmission
   - 6.2. A mechanical five-speed transmission
      6.2.1. Technical characteristics
      6.2.2. Removal and transmission installation
      6.2.3. Dismantling and transmission assemblage
      6.2.4. Dismantling and assemblage of the block of gear wheels
    6.3. Automatic transmission Ford With 3
7. A kardannyj shaft and the back bridge
8. A steering
9. Suspension brackets
10. Brake system
11. A body
12. An electric equipment



6.2.2. Removal and transmission installation

Removal

PERFORMANCE ORDER
1. To establish the car over the viewing channel or to lift it on the lift.
2. To disconnect a wire of weight from the accumulator.
3. To unscrew the handle of the lever of a gear change.
4. To remove (depending on the equipment version) the average console or a shelf about the gear change lever.
5. To remove an external casing of the lever of a gear change after its detachment from the holder, and also an internal casing together with the holder after unscrewing of a frame of the holder from a floor tunnel.
6. To disconnect the lever of a gear change from a back part картера transmissions.
7. To lift the car.
8. To disconnect the stabilizer from a longeron.
9. To disconnect rubber elements of a suspension bracket from скоб fastenings of a back part of final system and to fix all system so that did not load fastening of its forward part.
10. To unscrew fastening of the average bearing карданного a shaft, and also to unscrew fastenings карданного a shaft to a flange of a leading shaft of the main transfer about the back bridge.
11. To take a forward part карданного a shaft from back картера transmissions and to muffle a corresponding stopper an aperture in a back part картера for prevention вытекания oils from a transmission.
12. By means of a jack through wooden to prop up бруски a transmission.
13. To unscrew a cross-beam of fastening of a transmission to a body.
14. To remove a spring hook of fastening of a cable of a drive of a speedometer and to disconnect a cable from to - sh transfers.
15. To disconnect an electric wire from the switch of fires of a backing.
16. To remove a starter.
17. To disconnect a cable of coupling from deenergizing plugs.
18. To unscrew bolts of fastening of a transmission to an intermediate plate.
19. To remove the jet lever of knot the engine – a transmission.
20. To disconnect a transmission from the engine and cautiously to take a transmission from under the car.

Installation

PERFORMANCE ORDER
1. To cover шлицы a primary shaft with a greasing small amount.
2. Transmission installation is carried out in sequence of return in relation to removal process. After installation it is necessary to check up oil level in a transmission.